Installation of countertop models (ct) – Puratron Products AQUA2000 User Manual

Page 4

Advertising
background image

3

8

Installation of Countertop Models (CT)

The AQUA2000 is ready to install to most faucets. Installation takes just a few
minutes and requires a pair of pliers.

NOTE: The unit must be installed vertically (not horizontal)

WARNING: Remove protective packaging from inside the UV lamp housing
before operation.

1. Remove the existing aerator and gasket from the faucet. If the threads on the

hose assembly do not match your faucet’s threads, use the included adapter or
obtain one from your local hardware store.

2. Thread the hose assembly onto the faucet.

3. Connect the shorter tubing of the diverter assembly to the inlet of the system by

simply pushing the metal tube all the way into the lower fitting (located at the
rear of the unit, towards the bottom).

4. Connect the longer tubing to the outlet of the system by pushing the metal tube

all the way into the top fitting (located in the cap of the filter chamber).

5. Place hoses as shown and plug the power supply into a nearby receptacle.

IMPORTANT: Do not plug your AQUA2000 unit into an outlet that can be
turned off with a switch, such as an outlet for a garbage disposal.

Q. Can I install the filter under my sink?

A. Yes, you will need to purchase the under counter kit. The installation

instructions will be included with the kit.

Q. Can I use a different brand post filter, such as the one from my local home

center?

A. It is not recommended to use any other post filters. Our filters are specially

designed for use with the AQUA2000. Using any other brand filters may

cause undesirable results and could void the warranty and certifications.

Q. How do I obtain parts or filters?

A. You can buy parts or filters through your local dealers or service centers. You

can find your local service center by visiting www.rppurchase.com or by calling

866-786-8946.

Q. Can I use the AQUA2000 with my RV, boat, etc.?

A. Yes, as long as the water pressure is 15min - 100max psi and you don’t have

to alter the AQUA2000’s design. Altering the AQUA2000 will void the
warranty.

Q. Can I use the AQUA2000 in a hotel room?

A. You can use the filter anywhere you have a power source and a standard faucet

that you can connect to without having to alter the AQUA2000’s design.

B-6280 BR7242R-1 9/8/06 2:23 PM Page 4

Advertising