Panasonic EY6535 - Manual (Page 8)

— 8 —
Using Keyless drill chuck
(EY9X003E)
CAUTION: • Use keyless drill chuck ONLY in
Drill Driver Mode of EY6535.
This chuck is not designed to be
used in IMPACT MODE.
It can be damaged and its life will
be reduced. Moreover, the chuck
and its metal parts, such as the
push button, front parts, and bit
may become very hot. To prevent
skin burns, use work gloves and/or
allow heated parts to cool down
before handling.
• Make sure the work environment is
safe. When retracting drill from
work material, Keyless drill chuck
may detach if subjected to 100kg
or more of pull force. Detachment
will be sudden. Use care and avoid
excessive force when retracting
drill from work material.
1. Attaching Keyless drill chuck
Attach the chuck by sliding the female detent
on the bottom of the chuck to the square drive
on the body.
Make sure the chuck is firmly connected to the body
2. Inserting the bit
Insert the bit, and turn the lock collar clock-
wise(looking from the front) holding the sleeve
until jaws close firmly.
3. Removing the bit
Turn the lock collar counterclockwise (looking
from the front).
Then remove the bit.
CAUTION: If the drill bit becomes too tight to
remove, hold two lock collars with
pipe wrenches and turn them in
opposite directions.
4. Detaching Keyless drill chuck
To detach the chuck, PUSH the button to
release the chuck from the square drive.
CAUTION: Drill bit blade is sharp. Make sure to
remove the drill bit before you set
and detach the keyless drill chuck.
1
2
2
1
PUSH
EY6535.book 8