Connecting am/fm antennas, Connecting external antennas, Multi-zone setup – Pioneer VSX-1325-K User Manual

Page 30: Connecting your equipment 03

Advertising
background image

Connecting your equipment

03

30

En

Connecting AM/FM antennas

Connect the AM loop antenna and the FM wire antenna
as shown below. To improve reception and sound quality,
connect external antennas (see Connecting external
antennas
below).

1

Pull off the protective shields of both AM antenna

wires.

2

Push open the tabs, then insert one wire fully into

each terminal, then release the tabs to secure the AM
antenna wires.

3

Fix the AM loop antenna to the attached stand.

To fix the stand to the antenna, bend in the direction
indicated by the arrow (fig. a) then clip the loop onto the
stand (fig. b).

• If you plan to mount the AM antenna to a wall or other

surface, secure the stand with screws (fig. c) before
clipping the loop to the stand. Make sure the
reception is clear.

4

Place the AM antenna on a flat surface and in a

direction giving the best reception.

5

Connect the FM wire antenna into the FM antenna

socket.
For best results, extend the FM antenna fully and fix to a
wall or door frame. Don’t drape loosely or leave coiled up.

Connecting external antennas

To improve FM reception, connect an external FM
antenna to FM UNBAL 75

Ω.

To improve AM reception, connect a 5 m to 6 m (16 ft. to
20 ft.) length of vinyl-coated wire to the AM LOOP
terminals without disconnecting the supplied AM loop
antenna.

For the best possible reception, suspend horizontally
outdoors.

MULTI-ZONE setup

This receiver can power up to three (VSX-1325)/two (VSX-
1125) independent systems in separate rooms after you
have made the proper MULTI-ZONE connections.
Different sources can be playing in three (VSX-1325)/two
(VSX-1125) zones at the same time or, depending on your
needs, the same source can also be used. The main and
sub zones have independent power (the main zone power
can be off while one (or both) of the sub zones is on) and
the sub zones can be controlled by the remote or front
panel controls.

Important

• The explanations for ZONE 3 below only apply to the

VSX-1325.

ANTENNA

FM UNBAL 75

AM LOOP

3

4

5

fig. a

fig. b

fig. c

1

2

ANTENNA

FM UNBAL 75

AM LOOP

75

Ω coaxial cable

ANTENNA

FM UNBAL 75

AM LOOP

Outdoor antenna

Indoor antenna

(vinyl-coated wire)

5 m to 6 m

(16 ft. to 20 ft.)

VSX-1325_UXJCB.book 30 ページ 2010年3月9日 火曜日 午後3時4分

Advertising
This manual is related to the following products: