Panasonic DMR-EZ47VEB - Manual (Page 10)

10
RQT8857
Power Save
On: Minimise standby power
consumption, without
Quick Start function and
AV2 loop-through in standby.
Off: With Quick Start
function and AV2 loop-through
in standby.
OK RETURN
SELECT
On
Off
Power Save Function:
,  to select “On” or “Off”
then
OK
– Set to “On” to reduce power
consumption in standby mode.
– Refer to the following chart for the Power Save function features
when the unit is turned off.
* e.g., TV Guide is displayed within 1 second after [GUIDE] is pressed.
Power Save On Off
Power consumption Approx. 2.2 W Approx. 13.4 W
Watching the picture from the
satellite receiver connected
to the AV2 input terminal
Can not do Can do
Startup time Not quick Quick*
¦
DVD/VHS
to turn the unit on.
DVB Auto-Setup starts. The unit will search
for the terrestrial digital channels. This takes
about 5 minutes.
– TV channels are sorted and stored in
channel numbers order sent by the
broadcasters and cannot be changed.
When setup has completed, the confi rmation screen appears.
OK
The Owner ID settings screen appears.
 and press the numbered buttons to enter
your choice of a 4-digit PIN number.
Owner ID
RETURN : leave
PIN number ____
Name
House No.
Postcode
RETURN
Make a note of the PIN number (don’t
forget), as it is not possible to return to
the factory preset.
OK to store the PIN number.
Preparation:
 Turn on the mains for the television
(and connected equipment) and select
the appropriate AV input to suit the
connections to this unit.
 These are the first settings you make upon
buying the unit. You don’t need to make
these settings again.
STATU A A S
CREAT A A E
CHAPTER
FU
NC
TIO
N M
EN
U DI
RE
CT
NA
VA
IG
ATAA
OR
GUIDE
RETURN
PLAY PA PP USE STOP
SLOW/SEARCH
CH
SELECT
INPUT 0
9 8 7
6 5 4
3 2 1
CH
AV A A
¦
TV
DRIVE
SELECT
¦
DVD/VHS
VOL
DELETE MANUAL SKIP
PROG/CHECK
EXIT
OK
OPTION
TRACKING/V-LOCK/PAGE
SKIP/INDEX
RESET
REW FF

11
10
Tips
To abort Auto-Setup
Press [RETURN].
 If the unit displays “No stations found !”
Press [ ] to select “No” and press [OK].
Go to step . After you have performed
steps -, turn off the unit and confi rm
the cable or aerial input is connected to
the RF IN terminal. Restart the Auto-
Setup again (
¼ 59).
 If the clock setting menu appears or
the clock is not correct, set the clock
manually (
¼ 11).
Restarting the Auto-Setup ( ¼ 59)
 When turning on the Power Save
function, if the unit is turned off, unit’s
display is also turned off.
To correct the PIN number
1. Press [
, ] to select the digit.
2. Press the numbered buttons to enter
the digit.
TV’s remote control
DVB Auto-Setup
Please wait! Ch 21 68
Prog. Quality Channel Service Name Net ID TS ID
RETURN
RETURN: to cancel
BBC ONE
BBC 23
23 1
2 12302 12289
12302 12289 9
9
Setting the Channels and Clock