Panasonic AW-HB605 - Manual (Page 5)

9 8
Controls and Their Functions
: Camera Control Signal Input
Connector [TO CONTROL PANEL
CAM CONT IN] (BNC Connector)
Connect this connector to the camera
control signal output connector [TO
CAMERA PAN/TILT HEAD CAMERA
CONTROL OUT] of the hybrid control
panel (AW-RP501), or to the camera
control signal output connector [TO
CAMERA PAN/TILT HEAD CAMERA
CONTROL OUT] of the multi hybrid
control panel (AW-RP505) using a
coaxial cable (5C-2V equivalent).
If the system incorporates a pan/tilt
control panel (AW-RP301) or multi
pan/tilt control panel (AW-RP305), the
control panel is not equipped with a
camera control output connector. In this
case, this connector should be left
unconnected.
; Black Burst Output [BLACK BURST
OUT] (BNC Connector)
This is the output jack for the reference
signal generator built into the multi
control hub. This signal may be used as
the reference signal for peripheral
equipment that uses external
synchronization.
Controls and Their Functions
6 Black Burst Output [TO PAN/TILT
HEAD HUB BLACK BURST OUT]
(BNC Connector)
This is the output jack for the reference
signal generator built into the multi
control hub. This signal may be used as
the reference signal if the camera uses
external synchronization.
Connect this connector to the G/L signal
input connector [G/L IN] of the pan/tilt
head, or to the G/L signal input
connector [TO CONTROL PANEL G/L
IN] of the multi port hub using a coaxial
cable (5C-2V equivalent).
7 Camera Control Output Connector
[TO PAN/TILT HEAD HUB CAM CONT
OUT] (BNC Connector)
Connect this connector to the camera
control signal input connector [CAMERA
CONTROL IN] of the pan/tilt head, or to
the camera control signal input
connector [TO CONTROL PANEL
CAMERA CONTROL IN] of the multi
port hub using a coaxial cable (5C-2V
equivalent).
8 Pan/Tilt Head Control Signal Input
Connector [TO CONTROL PANEL
PAN/TILT CONTROL IN] (RJ-45 8-pin
Modular Jack)
Connect this connector to the control
panel pan/tilt control signal output
connector [PAN/TILT CONTROL OUT]
of the control panel using a 10BASE-T
(UTP category 5) straight cable.
9 Preview Video Signal Output
Connector [TO CONTROL PANEL
PREVIEW OUT] (BNC Connector)
Connect this connector to the video
input connector [TO CAMERA
PAN/TILT HEAD VIDEO IN] of the
hybrid control panel (AW-RP501), or to
the preview video input connector
[PREVIEW IN] of the multi hybrid control
panel (AW-RP505) using a coaxial cable
(5C-2V equivalent).
If the system incorporates a pan/tilt
control panel (AW-RP301) or multi
pan/tilt control panel (AW-RP305), the
control panel is not equipped with a
video input connector. If necessary, the
output from the preview video signal
output connector may be connected to a
monitor video screen, VCR, or the like
via a cable compensation device.