Porter-Cable QUICKSAND 332 - Manual (Page 10)

10
FUNCTIONAL DESCRIPTION
FOREWORD
The Porter-Cable Random Orbit Sanders provide rapid stock removal with
80 to 100 grit paper and swirl-free finishing with 120-150 grit paper. Model
332 is equipped to accept 5" diameter STIKIT™ adhesive paper backed
abrasives. Model 333 is equipped to accept 5" hook & loop backed
abrasives with five dust extraction holes. Model 333VS is equipped to
accept 5" hook & loop backed abrasives with five or eight dust extraction
holes. Model 334 is equipped to accept 5" diameter STIKIT™ adhesive
backed abrasives with five dust extraction holes.
Fig. 1
A
Fig. 1A
A
B
INSTALLING/REMOVING ABRASIVE DISC
Models 332 and 334:
1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2. Place machine on workbench with pad up (see Fig. 2).
3. Clean dust from pad face.
4. Tear a new abrasive disc from roll and position disc to the sander pad.
Align the dust extraction holes in paper with holes in pad (334 ONLY).
5. Press disc firmly onto pad.
6. Position machine with abrasive contacting scrap material. Start machine
and operate momentarily while exerting firm pressure to seat disc to pad.
Failure to properly seat disc to pad may result in disc
being thrown from pad causing personal injury.
7. To remove disc, peel disc away from pad.
NOTE: Do not store machine with an abrasive disc installed. Heat
generated by the sanding operation increases the adhesive bond
between the disc and pad. If disc is left on pad for an extended time
after use, it can become difficult to remove.
ASSEMBLY TOOLS REQUIRED - None
ASSEMBLY TIME ESTIMATE - 15 to 30 minutes
ASSEMBLY