Panasonic SC-HT730 - Manual (Page 7)

7
RQT7972
4
Connect the speaker cables.
5
Fasten the speaker cable to the base.
≥Using the same polyfoam as in procedure 2 will assist you in
safely and securely fastening the speaker cables.
∫ Preventing the speakers from falling over
Preparation
Attach screw eyes (not included) to secure the speakers to the wall
(
➜ diagram below).
≥You will need to obtain the appropriate screw eyes to match the
walls or pillars to which they are going to be fastened.
≥Consult a qualified housing contractor concerning the
appropriate procedure when attaching to a concrete wall or a
surface that may not have strong enough support. Improper
attachment may result in damage to the wall or speakers.
To prevent the speaker from falling over, thread the string (not
included) from the wall to the speaker as shown and tie tightly.
Rear of the speaker
_:
Copper
`:
Silver
Push !
If there is any excess speaker cable, thread
the speaker cable into the opening near the
top of the pipe while pulling the speaker
cable from the bottom of the base.
Press the speaker cable into the
groove.
Twist off the vinyl tips of the speaker
cables.
≥If the speaker cables do not have vinyl
tips, directly connect them to the
terminals.
2 Fit the speaker
cable into the
base cover
groove as far as
possible.
1 Press the speaker
cable and thread
between the
hooks.
Rear side of base Cable
[HT730]
[HT733]
String (not included)
Rear of the speaker
Wall
Approx.
150 mm
(5
29 / 32
z)
Screw eye (not included)
[HT930]
[HT933]
String (not included)
Rear of the speaker
Wall
Approx.
150 mm
(5
29 / 32
z)
Screw eye (not included)
String (not included)
Rear of the speaker Wall
Approx.
150 mm
(5
29 / 32
z)
Screw eye (not included)
F
ro
n
t sp
eak
er asse
mb
ly
7972en-p03-31.fm Page 7 Tuesday, June 7, 2005 4:24 PM