Philips Candlelight Set HF8430 - Manual (Page 10)

Note: The candles may go on when you put them on the charger. If they do,
remove the candles from the charger and tilt them to switch them off. Then
put the candles back onto the charger.
Note: For safety reasons, a built-in timer stops the charging process after 12
hours, when the batteries are fully charged. If you have one or more
uncharged candles left and want to charge them right away, press the button
on the charger to start another charging cycle. When you do this, the
charging light goes on again.
preparing for use
Massager
cleaning
Thoroughly clean the massager before first use, after every use and
when you use it on another body area, to reduce the risk of
infection (see chapter ‘Cleaning’).
pre-warming the massager
The charger has a pre-warming button that you can use to pre-warm the
bottom of the massager to a comfortable temperature (approx. 40°C).
Never warm the massager in an oven or microwave.
1 Place the massager in ohe charger. It only fits properly on the
charger with the buttons facing up.
 Press the pre-warming button (Fig. 5).
The pre-warming light ring starts flashing to indicate that the
massager is warming up.
After approx. 5 minutes, the pre-warming light ring stops flashing
and lights up continuously to indicate that the massager has
reached a comfortable temperature.
After 0 minutes, the pre-warming function automatically switches
off, but you can also switch it off by pressing the pre-warming
button again.
,
,
,
EnglisH 10