Profoto D4 - Manual (Page 22)

D4 Profoto D4 – Profoto Studio Software
Profoto 38 The Light Shaping Company Profoto 39 The Light Shaping Company
2. Click on the tab of a single generator if you want to change this settings. Click the
FLASH POWER button to get access to the the power, modelling light, ready signals
and recycling mode control of all generators. The total power will be adjusted propor-
tionally to the settings done in the INDIVIDUAL mode. If one or more generator(s)
reaches maximum or minimum power, it isn’t possible to increase or decrease the
total power anymore. In this case it is necessary to adjust the power level of the
corresponding generator. Settings done in the ALL mode have priority – in the case
that one or more generators are set to different ready or modelling light modes, the
corresponding buttons are unmarked. Click on the desired function to set all generators
in the same mode.
3. It is possible to change the power level in 1/1 or 1/10 f-stops by clicking the corre-
sponding + and – buttons. The power of the lamp head(s) with max. and min. are
shown in relative f-stops and Ws. See page 23-24 for details about the energy distribu-
tion. In the upper part of the ALL control field you can enter a name for the set-up.
4. To use the auxiliary functions and/or set the radio slave channel, click the AUXILIARY
button. Now you can set all functions – see page 26-29 for details about the auxiliary
functions.
5. To save all settings, click the SAVE button in the field STORE OPERATIONS. Now it is
possible to recall this set-up by clicking the given name in the left field STORE first
and the RECALL button in the field STORE OPERATIONS next, even if the set-up was
deactivated or disconnected. The number of saved set-ups is just limited by the
computer memory available. It is also possible to check the different set-ups – if you
want to return to the previous settings, simply click UNDO in the STORE SELECTION
field. If you want to delete a saved set-up, mark the name of this set-up in the field
STORE field and click DELETE in the field STORE SELECTION.
If you click the TEST button and more than one D4 generator is connected, each generator
will flash immediately after each other. With this function it is possible to check that
all generators work properly. PLEASE NOTE! Make sure that the photo cells of all
generators are deactivated (”OFF” in the SLAVE field) if you want to check
them separately!
Form and control generator groups
With this function is it possible to combine generators to form separate groups and to adjust
groups like a single generator. This is very useful to control i.e. the whole main or background
light or if more than one D4 is used to power a huge light bank.
1. Click the INDIVIDUAL tab to get access to the control functions of each single
generator, see “Individual Control” at page 36-37 for details.
2. Select the first generator you want to include and write a group name in the field
GROUP and save the chosen name by pressing the return/enter key of the computer.
The group name you created is now also available for all other generators connected
and you can add more D4 generators to this group by selecting this name in the
GROUP field and clicking the SAVE button in the STORE OPERATIONS field.
3. Click the GROUP tab and select the name of the group you want to form in the field
GROUP: Now all generators with this group name are combined and are not available
anymore under the INDIVIDUAL tab.
4. To change the settings of a single generator in the corresponding group, click the tap
with the generator’s name under the GROUP tab. To get access to the settings of the
complete group, click the tab with the group’s name under the GROUP tab.
See “Control all” at page 37 for details.
5. If you want to delete the actual group, select the given name in the GROUP field and
click DELETE GROUP.
Profoto D4 – Profoto Studio Software D4