Perle Systems c-1111-xxxxx - Manual (Page 8)

Perle 10/100/1000 Media Converter Module – Installation Guide 8
The following diagram is an illustration of the operation of this
feature.
(A) – Remote Media Converter setup for Fiber Fault Alert Enabled,
Fiber Negotiation – OFF and Link Mode – Standard.
(B) – Local Media Converter setup for Fiber Fault Alert -Enabled,
Smart Link Pass-Through - Enabled and Fiber Negotiation - OFF
(A) Loses fiber connection on its receiver.
(A) Disables fiber transmitter.
(B) Detects loss of link on its fiber receiver.
(B) Drops link on copper connection because Smart Link Pass-
Through is configured.
(A) Link on copper connection is not affected because Smart Link
Mode is set to Standard.
Duplex copper (Switch 4)
Switch Position Mode
Up (default) Full
Down Half
Note: When Auto Negotiation (SW1) is set to Off, the Media
Converter will use this Duplex setting for its copper connection.
Up: The Media Converter Module will be set to Full Duplex mode.
Down: The Media Converter Module will be set to Half Duplex
mode.