Pioneer CT-W208R - Manual (Page 11)

11
SINGLE PLAYBACK (Either DECK I
or DECK II)
1. Load a prerecorded tape in DECK I or II.
2. Set the DOLBY NR switch.
÷ Always set the switch to the same position
that was used for recording.
3. Set the REV MODE switch (see page 9).
4. Set the stereo amplifier for tape playback.
5. Press the playback ( 3 or 2) button of either
DECK I or II.
To stop playback temporarily(DECK II only)
Press the pause (
8) button.
÷ To resume playback, either press the pause (8)
button again, or press the playback ( 3 or 2) button.
To stop playback
Press the stop (
7) button.
NOTE:
When the play button (forward) is pressed during fast
forward, the unit will play back in the reverse direction,
and then play back in the forward direction. (vice versa
for reverse)
Example: When
3
is pressed during fast forward:
PLAYBACK
AUTO REVERSE
Auto Tape Selector
MUSIC SEARCH SYSTEM / PLAYBACK
Auto Tape Selector
MUSIC SEARCH SYSTEM / PLAYBACK
STEREO DOUBLE CASSETTE DECK
NORMAL HIGH
POWER
— OFF _ ON
HIGH SPEED COPY SYSYEM
MIN MAX
REC
LEVEL
REV MODE
RELAY/SKIP
COPY I II 3
DOLBY B-C NR
Ωı¿ˆ<?˘B
DECK @ II DECK @ I
Î
DOLBY NR OFF B C
DECK @ II
MS MS
+
–
+
–
DECK I
AUTO REVERSE
DECK II
(5) (1) 5 1
2 3
Fast
forward
Forward
play
= = stop =
Reverse play
(0.5 seconds)
= stop
This function allows you to skip unrecorded portions
of the tape during playback.
Set the REV MODE switch to
.
NOTES:
÷ When the REV MODE switch is set to the
position, the relay mode will be selected.
÷ When this mode is selected, if the tape deck encoun-
ters an unrecorded portion of tape more than 15 sec-
onds in length, it will fast forward the tape until it
encounters another recorded portion, and resume
playback from that point.
REV MODE
O p π
RELAY/SKIP
BLANK SKIP