Panasonic CF-U1 - Manual (Page 4)

4
G
e
tt
in
g S
ta
rt
e
d
Read Me First
Models for U.S.A.
Federal Communications Commis-
sion Radio Frequency Interference
Statement
Note: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This equip-
ment generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particu-
lar installation. If this equipment does
cause harmful interference to radio or
television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving
antenna.
Increase the separation between
the equipment and receiver.
Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
Consult the Panasonic Service
Center or an experienced radio/TV
technician for help.
Warning
To assure continued compliance, use
only shielded interface cables when
connecting to a computer or periph-
eral. Also, any changes or modifi ca-
tions not expressly approved by the
party responsible for compliance could
void the user’s authority to operate this
equipment.
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any inter-
ference received, including inter-
ference that may cause undesired
operation.
FCC RF Exposure Warning:
<Only for model with wireless LAN/
wireless WAN/Bluetooth>
This equipment complies with FCC
radiation exposure limits set forth
for an uncontrolled environment.
This equipment has been approved
for portable operation, and does not
require any minimum spacing be
provided between antennas and all
person’s body.
This equipment may not be co-
located or operated with any other
antenna or trasnsmitter.
<Optional Car Mounter/Port Replicator>
This equipment is provided with exter-
nal antenna connector(s) for connec-
tion to optional Car Mounter or Port
Replicator for mobile external mounted
antenna(s). External antenna(s) must
be professionally installed and cannot
exceed recommended maximum an-
tenna gain as described in individual
provided supplement instructions for
wireless transmitters. Also, user must
maintain minimum 20 cm spacing
between external antenna(s) and all
person’s body (excluding extremities of
hands, wrist and feet) during wireless
modes of operation.
25-M-2