Pioneer KURO PDK-TS36B - Manual (Page 5)

6
En
Forward/Backward Angle of Inclination Adjustment Mechanism
On this stand, you can adjust the angle of inclination of the
Pioneer television within a range of approximately 2° forward
or backward according to your preference.
œÌi
• Be sure to adjust the angle only after you have
attached the Pioneer television.
• Be sure to install it on a flat table or other flat
surface.
• Be sure to hold the top of the Pioneer television
with your hand while adjusting the angle.
Adjustment Procedure
1
Loosen the forward/backward inclination
anchor bolts using the enclosed C wrench (
locations on the left and right).
While being sure to hold the top of the Pioneer television
with your hand, loosen the forward/backward
inclination anchor bolts
on the left and right sides by
rotating them upwards using the enclosed C wrench.
'PSXBSECBDLXBSE
JODMJOBUJPO
BODIPS
CPMU
-PPTFOJOH
2
Set the angle you prefer.
Set the angle you prefer by slowly moving the Pioneer
television.
„ „
œÌi
While adjusting the angle, be very careful to keep your
hands out of the place indicated by the arrow on the
figure.
3
Tighten the forward/backward inclination
anchor bolts ( locations on the left and
right).
Firmly tighten the forward/backward inclination
anchor bolts
on the left and right sides by rotating them
downward using the enclosed C wrench.
Be sure to hold the top of the Pioneer television with your
hand until you have fully tightened the bolts.
'PSXBSECBDLXBSE
JODMJOBUJPO
BODIPS
CPMU
5JHIUFOJOH
4
Check once more to make sure that the
forward/backward inclination anchor bolts
are fully tightened.
PDK-TS36B_AZR1279B.indb 6 2008/07/07 9:32:33