Panasonic SD WV-NW484S - Manual (Page 14)

Names of Components (continued)
14
(1) Enclosure
(2) Mounting bracket (accessory)
(3) Network cable
(4) Alarm I/O cable
(5) Power cable
(6) Tilting lock screw
Fixes the tilt position after adjusting.
(7) Tilt adjustment seat
Adjusts the screen tilt.
(8) Panning table
Adjusts the horizontal angle of the
camera.
(9) Focus lever
Fixes the focus position.
(10) Panning lock screw
Fixes the panning position after
adjusting.
(11) Zoom lever
Fixes the zoom position after adjusting.
(12) Heater output connector
Used for connecting the heater unit
(sold separately) cable.
(13) INIT button (INIT)
Used for initializing setup.
(14) ABF button (ABF)
Used for starting ABF.
(15) LED ON/OFF switch button
Used for turning the link LED and
access LED on and off.
......................................................... Note
• The link LED and the access LED light
if the LED ON/OFF button is ON and
the LED display setting (
→ Setup
Manual) on the computer is set to "ON".
The LEDs do not light if the LED ON/
OFF button is OFF or the computer's
LED display settings is set to "OFF".
..............................................................
Important
• In regular operation, set this switch to
off. Lighting of the LEDs may reflect on
the dome and be included in the image
on screen.
(16) Access LED (ACT)
This LED indicates the reception status.
(17) Link LED (LINK)
This LED indicates the network link
status.
(18) ABF LED (ABF)
This LED indicates the busy status of
the ABF.
(19) Monitor output jack
Used for connecting the monitor for
confirming images at camera installa-
tion.
(20) SD memory card slot
(21) SD memory card error LED
This LED indicates the SD memory
card error status.