Pioneer DV-275 - Manual (Page 36)

Additional information 08
36
En
Note
• Using the 16:9 (Wide) setting with a
standard 4:3 TV, or either of the 4:3 settings
with a widescreen TV, will result in a
distorted picture.
Resetting the player
Use this procedure to reset all the player’s
settings to the factory default.
1 Switch the player into standby.
2 Using the front panel buttons,
hold down the (stop) button and press
STANDBY/ON to switch the player back
on.
All the player’s settings are now reset.
Power reset
Use this procedure to switch the power off if
the player is unresponsive to any control from
the front panel or remote.
1 Press and hold the front panel
STANDBY/ON for 10 seconds.
When the power is completely off, you cannot
use the remote to switch it back on again. Use
the front panel
STANDBY/ON button.
DVD-Video regions
All DVD-Video discs carry a region mark on the
case somewhere that indicates which
region(s) of the world the disc is compatible
with. Your DVD player also has a region mark,
which you can find on the rear panel. Discs
from incompatible regions will not play in this
player. Discs marked
ALL will play in any
player.
The diagram below shows the various DVD
regions of the world.
Selecting languages using the
language code list
Some of the language options (such as ‘DVD
Language’ in the Setup Navigator) allow you to
set your prefered language from any of the 136
languages listed in the language code list on
page 37.
1 Select ‘Other Language’.
2 Use the / (cursor left/right) buttons
to select either a code letter or a code
number.
3 Use the / (cursor up/down) buttons
to select a code letter or a code number.
See Language code list on page 37 for a
complete list of languages and codes.
1
2
2
5
5
6
3
2
1
4
4
DV-270_KU_VRB1328A.book 36 ページ ２００３年１２月５日 金曜日 午前１１時４０分