Porter-Cable 5043 - Manual (Page 2)

1. KEEP WORK AREA CLEAN. Cluttered areas and benches invite
injuries.
2.
AVOID DANGEROUS ENVIRONMENT. Don’t expose power tools to
rain. Don’t use power tools in damp or wet locations. Keep area well lit.
Avoid chemical or corrosive environment. Do not use tool in presence of
flammable liquids or gases.
3.
GUARD AGAINST ELECTRIC SHOCK. Prevent body contact with
grounded surfaces. For example: pipes, radiators, ranges, refrigerator
enclosures.
4.
KEEP CHILDREN AWAY. Do not let visitors contact tool or extension
cord. All visitors should be kept away from work area.
5.
STORE IDLE TOOLS. When not in use, tools should be stored in dry,
and high or locked-up place – out of the reach of children.
6.
DON’T FORCE TOOL. It will do the job better and safer at the rate for
which it was intended.
7.
USE RIGHT TOOL. Don’t force small tool or attachment to do the job
of a heavy duty tool. Don’t use tool for purpose not intended – for example
– do not use a circular saw for cutting tree limbs or logs.
8.
DRESS PROPERLY. Do not wear loose clothing or jewelry. Loose
clothing, draw strings and jewelry can be caught in moving parts. Rubber
gloves and non-skid footwear are recommended when working outdoors.
Wear protective hair covering to contain long hair.
9.
USE SAFETY GLASSES. Wear safety glasses or goggles while op-
erating power tools. Also face or dust mask if operation creates dust. All
persons in the area where power tools are being operated should also
wear safety glasses and face or dust mask.
10. DON’T ABUSE CORD. Never carry tool by cord or yank it to
disconnect from receptacle. Keep cord from heat, oil, and sharp edges.
Have damaged or worn power cord and strain reliever replaced
immediately.
11. SECURE WORK. Use clamps or a vise to hold work. It’s safer than
using your hand and it frees both hands to operate tool.
12. DON’T OVERREACH. Keep proper footing and balance at all times.
13. MAINTAIN TOOLS WITH CARE. Keep tool cords periodically and if
damaged, have repaired by authorized service facility. Inspect extension
cords periodically and replace if damaged. Have all worn, broken or lost
parts replaced immediately. Keep handles dry, clean and free from oil
and grease.
14. DISCONNECT TOOLS when not in use, before servicing, and when
changing accessories such as blades, bits, cutters, etc.
15. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of
checking to see that keys and adjusting wrenches are removed from the
tool before turning it on.
16. AVOID UNINTENTIONAL STARTING. Do not carry a plugged-in
tool with finger on switch. Be sure switch is off when plugging in. Keep
hands, body and clothing clear of blades, bits, cutters, etc. when
plugging in the tool.
17. OUTDOOR USE EXTENSION CORDS. When tool is used outdoors,
use only extension cords marked “Suitable for use with outdoor
appliances – store indoors when not in use.”
18. STAY ALERT. Watch what you are doing. Use common sense. Do
not operate tool when you are tired or while under the influence of
medication, alcohol or drugs.
2