Patriot Products Commercial Antenna Polar Mount User Manual
Page 10
Advertising
10
8. Install Anenna Panels noting overlay of joining edge. Join 2 panels to one Radial Beam
using 1/4” Allen Bolts from the Reflector and Feed pack. Work out from the hub (note edge
overlay should be even) Tighten the hardware into each J-clip after all hardware is in place.
9. Install 48- 1/4” Allen bolts with flange nuts to Antenna Panel perimeter edge and Outboard
Skirts tightening them as they are installed.
10. Tighten all Reflector hardware at this time.
Advertising