Panasonic PT-AE2000U - Manual (Page 38)

Settings
POSITION menu
38 -
E
NGLISH
WSS (Wide Screen Signalling) detects if a PAL/
625p (576p)/625i (576i) signal is input and that signal
has an identification signal, and switch the aspect ratio
to required setting automatically. You can switch the
system off manually.
If the 4 edges of an image is partly dropped, you can use
this function to adjust and project it properly.
Setting range: 0 to +10
OVER SCAN is not available with COMPUTER
signals.
If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled surface,
you can vertically correct keystone.
Setting range: -32 to 32
You can adjust V - POSITION, H - POSITION, DOT
CLOCK and CLOCK PHASE automatically when
connecting via COMPUTER IN. Press ENTER to adjust
these at the same time.
WSS
OVER SCAN
Enlarge Shrink
KEYSTONE
Image Operation
NOTE:
• You can correct the distortion ± 30 degrees from the
vertical plane. For a better quality image, installing the
projector with a minimum of distortion is recommended.
• Some distortion may be retained for the lens shift
adjustment.
• The distortion of the main menu screen is not
correctable.
• The result of the keystone correction will affect the
aspect ratio and the size of the image.
AUTO SETUP