PYLE Audio PLTVD7P - Manual (Page 8)

8
INSTALLATION
1. Remove the two transport screws
Press OPEN button on the back of the unit to eject the screen display from the
base at a little angle then turn the monitor upward to display the two screw. And
then use the screwdriver to remove the two screws.
2. Push the monitor back into the monitor base unit until the screen engages with
OPEN button. Then attach the brackets on both sides of unit with screws (M4x5),
last install the unit with screws (M5x25). When fix the unit, you can slide the
screw (M5x25) to left side or right side to meet your needed position. In the figure
below, select two holes among the positions that marked 1, 2, 3 and 4 to fix the
bracket.
Remove the transport scerws
Open Button
SCREW
M5 x 25
SCREW
M4 x 5
SCREW
M4 x 5