Porter-Cable QUICKSAND 335 - Manual (Page 7)

7
INSTALLING/REMOVING ABRASIVE DISC
Hook & Loop Abrasive:
The “hook” side of the sanding pad must be exposed for use with hook &
loop abrasives (see REVERSIBLE PAD).
1. CAUTION: DISCONNECT MACHINE FROM POWER SOURCE.
2. Place machine on workbench with pad up (see Fig. 4).
3. Clean dust from pad face.
4. Position Hook & Loop Abrasive Disc onto sander pad, aligning the dust
extraction holes in paper with holes in pad.
CAUTION: Do not use PSA (Pressure Sensitive Adhesive) disc with
Hook & Loop pad as the disc may be thrown from the pad causing
personal injury.
5. Press disc firmly onto pad.
CAUTION: Failure to properly seat disc to pad may result in disc
being thrown from pad causing personal injury.
6. To remove disc, peel disc away from pad.
Fig. 2 Fig. 3
Fig. 4 Fig. 5
A
B
C
900007 - 02-28-01.QXD 9/26/02 11:46 AM Page 7