POLAR S120 - Manual (Page 4)

6 6 7 7
0.12" - 0.2"
3 - 5 mm
0.12" - 0.2"
3 - 5 mm
HOW TO WEAR THE HEART RATE MONITOR
1. Attach the transmitter to the elastic strap.
2. Adjust the strap length to fit snugly and
comfortably. Secure the strap around your
chest, just below the chest muscles, and
buckle it.
3. Lift the transmitter off your chest and
moisten the two grooved electrode areas
on the back.
4. Check that the wet electrode areas are
firmly against your skin and the Polar logo
is in a central, upright position.
5. Keep the wrist receiver within
3 feet/ 1 meter of your transmitter.
HOW TO MEASURE HEART RATE
The display is blank when the receiver leaves
the factory. When using the receiver for the
very first time, activate the blank display by
pressing OK twice. Time of day will appear.
1. Starting with the display showing the time
of day, press OK. Your heart rate appears in
a few seconds.
2. Press OK again. The stopwatch starts running. Your exercise
data is now being recorded.
3. Press Stop twice to stop heart rate monitoring.
IF PROBLEMS OCCUR: SOURCES OF DISTURBANCE
If the heart rate reading is irregular or abnormal, or if there is no
heart rate reading at all, check that
• the two grooved electrode areas on the back of the
transmitter are moistened
• there is no one else using a heart rate monitor within
3 feet/ 1 meter
• you are not near high voltage power lines, televisions, mobile
phones or other sources of electromagnetic interference.
S150: INSTALLING THE POLAR BIKE
MOUNT AND THE SPEED SENSOR
ADAPTER
Check that the Bike Mount fits snugly on the
handlebar. If necessary, attach the rubber pad
on the inner surface of the Bike Mount.
Use cable ties to secure the Bike Mount
snugly on the handlebar. The correct place is
on the right side of the handlebar. Attach the
adapter to the Bike Mount so that the wire is
pointing to the left. Press the adapter so that
it stays firmly in its place. Attach the receiver
snugly by securing the wrist strap.
S150: INSTALLING THE SPEED SENSOR
1. Check the front side of the right front
fork to find a suitable place for the speed
sensor. Clean and dry the area.
Riding
direction
Riding
direction
7 7
manual S120 150 USA GBR B 18/7/02, 15:57 6-7