Pinnacle Speakers 66 - Manual (Page 6)

5
CONNECTIONS:
Please note that usage of the SLIMsub 66 with any amplifier other than our custom designed
PIN AMP 800 is not recommended and will result in seriously degraded performance or product
damage. Complete all wire connections in your Home Theater / sound system before powering up your
receiver or subwoofer(s). Be sure to observe proper polarity for all subwoofer wire connections
(+ to +, - to -). To obtain the best performance, use only speaker wire of 12, 14, or 16 gauge (available
from your dealer). Lightweight speaker wire (20, 22 gauge, etc.) will result in degraded performance;
16 gauge wire may be used for short runs of about 8 feet or less. When flush wall mounting, or placing
the unit on it's back, be sure to use the wire channel on the back of the cabinet.
•
For One Subwoofer: Wire your Subwoofer to the top Subwoofer Output binding posts on the
PIN AMP 800; be sure to observe proper polarity (+ to +, - to -).
•
For Two Subwoofers: Wire one Subwoofer to the top Subwoofer Output binding posts on the
PIN AMP 800, the other to the bottom set of Subwoofer Output binding posts; be sure to observe
proper polarity (+ to +, - to -).
•
For Four Subwoofers: Wire four Subwoofers to the PIN AMP 800 in a series / parallel fashion as
depicted below (top Subwoofer Output+ to Sub 1+, Sub 1- to Sub 2+, Sub 2- to top Subwoofer
Output-, bottom Subwoofer Output+ to Sub 3+, Sub 3- to Sub 4+, Sub 4- to bottom Subwoofer
Output-).
•
Please refer to your PIN AMP 800 owner's manual for proper amplifier setup, adjustments
and troubleshooting.