Panasonic CF-72 Series - Manual (Page 25)

25
T
roub
leshooting
10
At the confirmation message , press 
Y
.
The operation of reinstallation for the hard disk starts au-
tomatically.
(In the case of Windows 2000, only Product Recovery
CD-ROMs 1 to 3 can be used.)
11 After the reinstallation procedure completes, the follow-
ing message will appear on the display.
Windows XP
Windows(R) XP Professional install wizard will start after reboot.
Restore process will execute more after Windows(R) XP Professional install
wizard.
Restart the computer after removing Product Recovery CD-ROM.
Windows(R) 2000 Professional install wizard will start after reboot.
Restore process will execute more after Windows(R) 2000 Professional install
wizard.
Restart the computer after removing Product Recovery CD-ROM.
Windows 2000
Remove the Product Recovery CD-ROM, then restart the
computer by pressing
Ctrl + Alt + Del .
12 When the message [Press F2 to enter SETUP] is displayed,
press
F2
and then run the Setup Utility.
If the password has been set, enter the Supervisor Pass-
word.
13
Press
F9
.
At the confirmation message, select [Yes] and then press
Enter . (The Setup Utility settings will return to their
default values. Even the security settings with the excep-
tion of the password(s) will return to their default values.)
Change the settings where necessary.
NOTE
If there are added functions that are not listed in the
Specifications of this Operating Instructions, we rec-
ommend disabling their device settings. If the settings
are enabled, additional operations may be necessary
during the Windows setup procedure. (We also rec-
ommend referring to the Supplementary Instructions,
if they are included with the computer.)
When the message [Operating System not found] is
displayed, press 
Ctrl
+ 
Alt
+ 
Del
and perform the operations from Step
12
to Step 15.
If you fail to press F2 in Step 12 , restart the com-
puter and perform the operations from Step 12 to Step
15
after finishing Windows setup procedure.
NOTE
14
Using either or , select [Exit] and then select
[Save Current Values], then press
Enter
.
At the confirmation message, select [Yes] and press
Enter
.
15 Turn the computer off, and then turn the computer on.
16 Perform the setup procedure for Windows by following
the instructions on the screen.
(Refer to the Supplementary Instructions, if they are in-
cluded with the computer.)
Windows 2000 Page 11
Windows XP page 12
17 Run the Setup Utility and change the settings where nec-
essary.
Do not cancel the reinstall procedure before it is
completed.
When a message appears instructing you to insert
the next CD, insert the recovery CD showing the
next number in the sequence, and then select [OK].
If the message “The media does not contain the cor-
rect file” appears, select [OK]. A message will ap-
pear instructing you to insert the next CD.
Confirm that the proper recovery CD has been in-
serted by opening the tray of the CD drive and then
close the tray, then select [OK].
CAUTION