Planar XP37W - Manual (Page 44)

V37EMBB-UD3_HDMI+ATSC 2005/12/15 上午 10:26
43
4. If the ATSC signal is found and locked, you will
see the Status message “Add No.XX 8VSB channel
success". Press Exit or Menu to leave the menu
and watch the program, or to scan other channels.
5. If the signal is not locked, you will see a "no
channel" message. You can scan the signal again or
refer to the signal level bar “Signal” for aligning
the direction of the antenna to improve the signal.
6. When the signal is locked you can check the signal
level.
7. Press the Exit button to return to the main menu or
press the Menu button to exit the menu system.
MENU
Button
ENTER
Button
0
Add No. 10 8VSB channel successfully.