Pella Clad Casement & Awning Window 801P0101 - Manual (Page 5)

4
INTERIOR SEAL
Caution: Ensure use of low pressure polyurethane window and door insulating foams and
strictly follow the foam manufacturer’s recommendations for application. Use of high pressure
foams or improper application of the foam may cause the window frame to bow and hinder
operation.
A. Apply insulating foam sealant 
OF
WINDOW
4HIS
SQUEEZE ™ Window and
Door Insulation Foam Sealant by the Dow Chemical Company,
ALLOW
PROCEEDING
Note: DO NOT completely fill the space from the back of the fin
to the interior face of the opening.
B. Check window operation
the window.
Note: If the window does not operate correctly, check to make sure it is still plumb, level,
square and that the sides are not bowed. If adjustments are required, remove the foam
with a serrated knife. Adjust the shims, and reapply the insulating foam sealant.
Interior
4A
B. Apply top flashing tape. Cut a piece of flashing tape long enough
TO
THE
THE
OVERLAPPING
О
О

О
О
О
C. Fold down top flap
D. Apply flashing tape to diagonal cuts. Cut pieces of
mASHING
3
INTEGRATING THE WINDOW TO THE
WATER RESISTIVE BARRIER (continued)