Painless Performance 60505 - Manual (Page 17)

6.4
TAIL SECTION INSTALLATION
6.4.1 Locate the tail section that you earlier separated from the engine group. Begin routing it towards
the rear of the vehicle. Be sure to avoid all sharp edges, moving or hot parts, or anything else that
may damage the harness.
6.4.2 If you ARE using the 4L60E transmission, route the 13-position connector to the transmission and
attach it.
6.4.3 If you ARE NOT using the 4L60E transmission, tape up the connector and store it in the harness.
6.4.4 Take the gray wire and route it to the fuel pump. This is the power wire for the fuel
pump.
6.4.5 Take the connector for the Vehicle Speed Sensor (VSS) and connect to the Vehicle Speed Sensor.
6.4.6 Tail Section Connections
WIRE COLOR # OF POSITIONS LABELED CONNECT TO:
IN CONNECTOR
Purple,
Yellow 2 VSS Speed Sensor
Gray Fuel Pump Fuel Pump
Light Green, White, Light Blue/White,
Tan/Black, Brown, Pink, Yellow/Black,
Red/Black, Pink/Black, Blue, Red,
Yellow/White,
Black 13 Trans Transmission
7.0
TROUBLE- SHOOTING INSTRUCTIONS
If you are having trouble with your engine running badly or not running at all, first perform basic trouble-
shooting (ensure that you are using the correct parts (Table 4.1), check for faulty connections, blown fuses,
connection of VATS module, spark, timing, fuel pressure, etc.), then see if the computer has stored a
trouble code in its memory.
13
FIGURE 6.23 VSS
FIGURE 6.24 Transmission Connection
TABLE 6.3 Tail Section Connections