Using your sonicare, Brushing instructions, Personalizing your brushing experience – Philips sonic toothbrush FlexCare 900 User Manual

Page 7: Brushing modes, Clean mode

Advertising
background image

3 green LEDs: 75-100%

2 green LEDs: 50-74%

1 green LED: 25-49%

1 flashing yellow LED: less than 25%

Note: If the battery charge of your Sonicare is low, you hear 3 beeps and 1

LED on the recharge gauge flashes yellow for 30 seconds after the 2-minute

brushing cycle.
Note: To keep the battery fully charged at all times, you may keep your

Sonicare on the charger when not in use. It takes at least 24 hours to fully

charge the battery.

Using your Sonicare

Brushing instructions

1

Wet the bristles and apply a small amount of toothpaste.



Place the toothbrush bristles against the teeth at a slight angle

towards the gumline.

3

Press the power on/off button to turn on the Sonicare.

4

Apply light pressure to maximize Sonicare’s effectiveness and let the

Sonicare toothbrush do the brushing for you.



Gently move the brush head slowly across the teeth in a small back

and forth motion so the longer bristles reach between your teeth.

Continue this motion throughout your brushing cycle.

Note: To make sure you brush evenly throughout the mouth, divide your mouth

into 4 sections using the Quadpacer feature (see chapter ‘Features’).



Begin brushing in section 1 (outside top teeth) and brush for 30

seconds before moving to section  (inside top teeth). Continue

brushing in section 3 (outside bottom teeth) and brush for 30

seconds before moving to section 4 (inside bottom teeth).

7

After you have completed the brushing cycle, you can

spend additional time brushing the chewing surfaces of your teeth

and areas where staining occurs. You may also brush your tongue,

with the toothbrush turned on or off, as you prefer.

Your Sonicare is safe to use on:

Braces (brush heads wear out sooner when used on braces)

Dental restorations (fillings, crowns, veneers)

Periodontal pockets

Personalizing your brushing experience
Sonicare automatically starts in the default Clean mode. To personalize

your brushing:

1

Prior to turning on the Sonicare, press the Personalized Brushing

button to toggle between modes and routines.

The green LED indicates selected mode or routine.

-

-

-

-

-

-

-

,

1

2

4

3

1

2

4

3

EngliSh

7

Advertising
This manual is related to the following products: