Panasonic DMR-EH50 - Manual (Page 15)

15
RQT8023
Ge
ttin
g
st
a
rte
d
∫ Connection to a stereo amplifier ∫ To enjoy multi-channel surround sound on
DVD-Video
Use one of the following connections to suit the antenna lead.
≥ If your television has both lead and coaxial VHF terminals, use
the lead connection to minimize signal loss.
∫ A single twin lead
∫ A twin lead and a coaxial cable
∫ Two twin leads
Use one of the following connections to suit the antenna terminals
on your television. Refer to the television’s operating instructions.
∫ A twin lead and coaxial plug terminal
∫ A twin lead terminal
∫ Two twin lead terminals
∫ Multiple antenna terminals
≥ Connect to one of the ANT terminals, then change the television’s
settings as necessary.
Connecting an amplifier or system component
If the antenna connector doesn’t match
S VIDEO VIDEO
OUT2O
U T 2
OUT1O U T 1 Y P B P R
COMPONENT COMPONENT
VIDEO VIDEO OUT OUT
(48 480p/ p/48 480i 0i)
AC IN
S VIDEO VIDEO
IN3IN
3
IN1IN
1
VH VHF / UHF UHF
G-LINK LINK
RF RF I N I N RF RF
OUT OUT
VIDEO VIDEO VIDEO VIDEO R-AUDIO-L R-AUDIO-L R-AUDIO-L R-AUDIO-L DIGITAL AUDIO OUT DIGITAL AUDIO OUT
(PCM/BITSTREAM) (PCM/BITSTREAM)
OPTICAL OPTICAL
OPTICAL IN
AUDIO IN
R L
Optical digital audio cable
Do not bend sharply when
connecting.
Insert fully, with this
side facing up.
Audio cable
This unit
Red White
Red White
Connect an amplifier with a built-in decoder
displaying these logo marks using an optical digital
audio cable and change the settings in “Digital Audio
Output” (
➡ 56).
≥ You cannot use DTS Digital Surround decoders not
suited to DVD.
≥ Output is not digital with DVD-Audio; however, you can enjoy it in
analog ( ➡ left).
[For digital playback, set “Play DVD-Audio in Video Mode” ( ➡ 55)
to “Video Mode (Video On)” when the DVD-Audio contains DVD-
Video.]
Amplifier’s rear panel
Amplifier’s rear panel
To OUT 1 or OUT 2
or
Other antenna connections to the unit
300–75 ≠ transformer from the antenna
(Flat) Twin lead
300
≠ cable
To this unit’s RF IN
terminal
from the antenna
(Flat) Twin lead 300 ≠ cable
To this unit’s RF IN
terminal
(Round)
75
≠ coaxial cable
VHF/UHF band mixer
from the antenna
To this unit’s RF
IN terminal
300–75 ≠ transformer
(Flat) Twin lead
300
≠ cable
VHF/UHF band mixer
Other antenna connections to the television
VHF/UHF band separator
Television
75 ≠ coaxial cable
VHF
UHF
75 ≠ coaxial cable
75–300 ≠ transformer
Television
VHF or
UHF
75 ≠ coaxial cable
VHF/UHF band separator
Television
VHF
UHF
ANT 2
ANT 1
Split out
Television
75 ≠ coaxial cable
EH50English.book Page 15 Tuesday, February 1, 2005 6:36 PM