Profoto D1 500 AIR - Manual (Page 15)

Profoto Air USB – Profoto Studio Air
15
www.profoto.com
Sync via cable
1. Connect a sync cord from the camera to the Sync Connector [12] on the D1 unit.
Sync via IR
1. Press and hold down the Slave Button [8a] until the IR Indicator [8c] is illuminated.
Sync via radio (D1 without Profoto Air)
1. Connect a Profoto Air Remote or Profoto Air Sync device (Receiver) with a cable to the
Sync Connector [12] on the D1 unit.
2. Follow the instructions for genera tors without built-in Profoto Air receiver in the
Profoto Air Remote/Profoto Air Sync User’s Guide.
Sync via radio (D1 with Profoto Air)
1. Press and hold down the Slave Button [8a] until the RADIO Indicator [8b] is illuminated.
2. Select radio channel by following the Radio settings instructions below.
3. Connect a Profoto Air Remote or Profoto Air Sync device to the camera.
4. Follow the instructions for generators with built-in Profoto Air receiver in the Profoto
Air Remote/Profoto Air Sync User’s Guide.
Radio settings (D1 with Profoto Air)
For sync via radio, the same radio channel has to be set on the D1 unit and the Profoto Air
device or the Profoto Studio Air program.
For remote control using Profoto Air Remote, the same radio channel and group ha ve to be
set on the D1 unit and the Profoto Air device.
For remote control using Profoto Air USB and Profoto Studio Air, the same radio channel
has to be set on the D1 unit and in the Profoto Studio
Air program.
1. Verify that the RADIO Indicator [8b] is illuminated on the D1 unit.
2. Press the Channel Set Button [6]. The Display [1] will start flashing, showing the
current radio channel number to the left and the radio group letter to the right.
3. While the Display [1] is flashing, turn the Setting Knob [7] clockwise to increase the
radio channel number (1 to 8) and counter-clockwise to decrease the number.
4. While the Display [1] is flashing, press and hold down and turn the Setting Knob [7]
clockwise to increase the group letter ( A to F) and counter-clockwise to decrease the
letter.
5. Wait until the Display [1] stops flashing. (The Display [1] will no w show the energy level
of the flash light.)
For radio channel and group settings on the Profoto Air devices and the Profoto Studio Air
program, please refer to the corresponding User’ s Guide.