Pioneer DVD-U02 - Manual (Page 13)

<DRC1083>
En
13
FORCED EJECTION METHOD IN CASE OF EMERGENCY
Confirm that the power supply of the computer is switched off and the
disc loading is stopped. It takes approx. 30 seconds to stop loading a
disc after switching off the power supply. While this operation, do not
execute the forced ejection.
Always use the pin provided (Do not use other objects).
Do not execute the forced ejection while loading a disc, an injury or a
disc damage will be caused.
Do not place anything within 12 cm (4.72 in.) in front of the unit as this
may obstruct the disc ejection operation of the unit.
¶ Use an accessory pin for emergency ejection, insert it straight into the hole for
forced ejection, and push strongly.
¶ As the disc will be ejected approx. 5-10 mm (3/16–3/8 in.) from the disc loading
slot, pull it out by fingers.
DISC OPERATION
DISC REMOVAL METHOD
¶ Confirm that the BUSY indicator of the drive is not lit, and then press the Eject
button (
0).
¶ Remove the disc after it has been ejected.
In the following cases, the disc can be removed using the forced ejection hole.
¶ In case of drive trouble, when the disc can not be ejected with the Eject button or
by a software command.
¶ When the disc is to be removed while the power is switched off.
Fig. 8