Panasonic P342i - Manual (Page 44)

45
Se
ttings
Settings
Me
n
u
> S
et
tin
g
s > Ca
ll s
er
vic
e
Viewing the combined details of your previous connections
Select Connections > All Connections.
The combined length of all your incoming or outgoing calls since the timer was last reset,
is displayed.
Once you have seen all the details you can reset the total time and data:

Press Q.

You are asked ‘Reset Total Time and Data?’. Press Q.

Enter the lock code.
Allowing incoming calls during data transfer
With this enabled, you can accept incoming calls while you are transferring data. With
this disabled, you cannot answer incoming calls while you are transferring data.

Select Connections > Call Priority.

Select On or Off.
Service charges
To maintain control over the cost of calls that you make, you can set the phone to restrict
its use to a specified number of units.
Setting the unit price
First you need to enter a price per unit. This is the amount that your service provider
charges for one unit of call time.

Select Service Charges > Price/Unit.

Enter your PIN2.

Enter the currency unit (maximum 3 characters).

Enter the unit price.
Note: The lock code is preset to 0000. For security you should change this to a four
figure number that you can remember, see Changing the phone lock code on
page 48.
Note: This is SIM and service provider dependent. This option is only available for ‘Pay
as you go’ SIMs.