ProForm 725 TL 831.297763 - Manual (Page 7)

5. Locate the section HOW TO FOLD THE TREADMILL
FOR STORAGE on page 18. Follow the instructions to
fold the treadmill.
Thread two more Handrail Bracket Screws (15) into the
right Handrail Bracket (42) and Frame (83). Firmly
tighten all four Screws in the Bracket. Thread two more
Screws into the left Handrail Bracket and Frame (not
shown). Firmly tighten all four Screws in the Bracket.
6. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 19. Follow the instructions to lower the treadmill.
Align the holes in the Book Rack (101) with the holes in
the Console Base (85). Attach the Book Rack with the
four Console Screws (6) as shown.
7. Attach the Pulse Sensor (114) to the Headband (115).
Make sure that the sensor window is pressed through
the indicated hole in the Headband.
Press open the clothes clip, and insert the pulse sensor
wire into the clothes clip.
Make sure that the pulse
sensor wire is resting against the hinge of the
clothes clip (see the inset drawing). The use of the
pulse sensor is explained on page 8.
8. Remove the backing from the Adhesive Clip (90). Press
the Clip onto the Upright Base (86) in the indicated loca-
tion. Press the Allen Wrench (89) into the Clip.
9. Make sure that all parts are tightened before you use the treadmill. Note: To protect the floor or carpet,
place a mat under the treadmill. For information on ordering a mat, see REPLACEMENT PARTS on the
back cover.
7
85
6
6
101
6
7
Clothes Clip
Pulse Sensor Wire
Sensor
Window
114
Hole
115
Clothes
Clip
Hinge
8
86
89
90
5
42
83
15