Pioneer SVM-1000 - Manual (Page 16)

USING THE VIDEO CONTROL FUNCTIONS
16
En
OPERATING IN THE VIDEO SOLO MODE
Setting video solo mode to ON allows instantaneous switching to
the desired channel’s video.
By combining with the FADER AV SYNC button ON/OFF, a variety
of operations is possible.
Whenever the power is first turned ON, the video solo mode is set
to OFF by default.
When the video solo mode is ON, the VIDEO SOLO MODE button
will flash.
When FADER AV SYNC is ON
• When the channel monitor is touched, output instantaneously
switches to the video of the touched channel.
• When the channel fader begins rising from the [0] position,
output instantaneously switches to that channel’s video.
When FADER AV SYNC is OFF
• When the channel monitor is touched, output instantaneously
switches to the video of the touched channel.
Upon changing the FADER AV SYNC from ON to OFF, the original
channel fader position will be maintained until the channel
monitor is touched again.
Operation of the video cross fader and [TRANS] button are not
supported in the video solo mode.
VIDEO MIX EFFECTS CHART
Video mix effects
Video cross fader
No Name Description of the effect
1 FADE Switches video while mixing.
2 WIPE Switches video while wiping away.
3 SWITCH Switches instantaneously (without mixing).
4 CHROMA-B Switches from the blue component of video on cross fader side [A] to the
video on side [B].
5 CHROMA-G Switches from the green component of video on cross fader side [A] to the
video on side [B].
6 LUMINANCE Switches from the dark portion of video on cross fader side [A] to the video
on side [B].
SVM-1000_B_En.book 16 ページ ２００７年１１月２６日 月曜日 午後１２時５４分