Before starting up – Planet Technology XRT-401E User Manual
Page 3
3
1. BEFORE STARTING UP
This is a step-by-step instruction on how to start up the
XRT-401E and get connected to the Internet.
1) Setup your network as shown in the setup diagram below.
2) Then, you need to setup your LAN PC clients so that it can
obtain an IP address automatically. By default the XRT-401E’s
DHCP server is enabled so that you can obtain an IP address
automatically.
Note
Please make sure that the XRT-401E’s DHCP server
is the only DHCP server available on your LAN.
If there is another DHCP on your network, then
you’ll need to switch one of the DHCP servers off.
3) Once your PC has obtained an IP address from your
router, enter the default IP address 192.168.0.1 into
your PC’s web browser and press <enter>. That is, key in
http://192.168.0.1 to the browser’s address field.