Powermatic COS18 - Manual (Page 14)

14
8-FOOT TABLE GUIDE
1. The 8-foot table comes with a guide and
scale. The guide should be mounted to the
edge of the table with six M8 x 27 square
head bolts, six M8 flat washers and six M8
hex nuts (Fig. 13).
2. Attach the three stops to the 8-foot table
guide (Fig. 13). These stops can be slid to
any point along the guide and secured by
tightening the lock levers.
LEVELING & ALIGNING ROLLER TABLES
Each roller table must now be leveled with the
main saw table and aligned with the fence. (The
fence must be square with blade – see "Squaring
the Fence", page 11.)
WARNING: Disconnect saw from both
air and electric power sources.
1. Select a piece of scrap board with a good
straight edge, 4 to 6 feet in length.
2. Raise the blade guard and keep it raised.
Place the board, straight edge down, on the
saw table surface and allow it to extend to
the second or third roller of the roller table
(Fig. 14).
3. Level the roller table by loosening the hex
nut on the foot pad and screw the foot pad in
or out. (see Fig. 12).
4.
When roller table and main table are level,
tighten the nuts on the foot pads.
!