Planar EL320.240-FA3 - Manual (Page 23)

Display Dimensions and Component Envelope
The Figure below shows the display dimensions. For additional details the
Mechanical Outline drawing is available at www.planar.com.
Note the 20.56 mm component envelope. This is the depth required by the
display to ensure no interference with display board components, which are
up to 12.19 mm in height. While tall components are the minority, Planar
reserves the right to relocate components
within the constraints of the
component envelope without prior customer notification. For this reason,
Planar advises users to design enclosure components to be outside the
component envelope.
Device designers will need to consider their specific system requirements to
determine the spacing necessary to maintain the specified ambient temperature
for the display electronics.
Air flow and the thermal properties of surrounding components will impact the
required depth of the air gap. In addition, electrical spacing must be considered
to accommodate the high voltage (up to 200 VDC) present on the display
electronics.
Figure: Display Dimensions (millimeters, ± 0.25 mm)
EL320.240-FA3 Operations Manual Page 23 of 25