Panasonic TX-47P950A - Manual (Page 28)

28
Aspect Controls
MENU TV/AV
N R-TUNE
OK
SURROUND
F.P. INDEX TV/TEXT HOLD
CH SEARCH STILL
MULTI PIP
ASPECT
ASPECT
16:9 14:9
4:3 ZOOM2
JUST
ZOOM1
AUTO
ZOOM3
AUTO
Explanation Picture Mode
4 : 3
ZOOM1
16 : 9
16:9 Signal
ZOOM2,
ZOOM3
16:9 Signal 4:3 Signal
The AUTO position can be set to 16 : 9. When a
wide screen signal is detected at the Video
terminal the TV will select the 16:9 aspect ratio.
This option will display a standard 4:3 picture
without any stretching or compression. There
will be vertical gray lines down either side of the
picture.
The picture becomes larger and larger when
you change the mode ZOOM2 and ZOOM3.
The 16:9 option will display the picture at its
maximum size. Signals in the 4:3 format will be
stretched to fit the picture.
This option allows you to magnify the picture.
JUST
JUST gives you a best fit option when showing
4:3 on wide screen. The centre of the picture is
not affected but there is some stretching at the
edges.
4:3 Signal
ZOOM1
ZOOM2
14 : 9
The 14:9 option will display a 4:3 signal in
simulated wide screen. The picture is slightly
stretched. It is also slightly cropped top and
bottom.
Helpful Hint ( N Normalization)
Press to select the different Aspect options.
Notes:
•
Simply press ASPECT ASPECT to display mode information in the top left of the screen. Whilst the on screen
selector keys are displayed, use the Red or Green buttons to move in either direction through the eight
aspect options.
• 16:9 picture has been used to illustrate all of the aspect modes described in this section.
The on screen selector keys (corresponding to the four coloured buttons on the remote control) appear for some Aspect functions
and disappear after a few seconds. If you would like to select an operation when the keys are not shown, press ASPECT
ASPECT once
more and the keys will reappear.
By pressing the Normal “N” Button on the Remote Control while the Aspect menu is displayed, the selected menu will be changed to
the Normal Mode.
Normalization will not occur if the menu is not displayed when the “N” Button is pressed.
The Normal mode is the factory preset condition. Returning to this original condition is called “Normalization”.
Notes:
•
ASPECT operations cannot be made during progressive (Y, P
B
, P
R
) or 1080i signal input.