Precision Power DCX 500.1 - Manual (Page 15)

12. -12dB Input Attenuation: Push this switch ‘IN’ for high voltage
(4V-12V) capability. This button pushed ‘IN’ must be used for
speaker level input on common ground head-units or for high
voltage line drivers.
13. Phase: Adjust the phase of the output relative to the amplifier
input.
14. RCA Outputs: RCA outputs provide HP/LP/FULL 30-4kHz
signal to another amplifier.
DCX-500.1, 1000.1, 1500.1 END PLATE DIAGRAMS
1. Power/Ground PowerLock TM : After you have securely
connected your power and ground wires, plug in the Power/Ground
PowerLock TM connector here. Note that the DCX1000.1 and
1500.1 have two of these receptacles. You must connect the power
and ground cables to both
PowerLock TM terminals for optimum
operation.
2.
QBASS REMOTE TM : Plug in the data cable from the optional
QBASS REMOTE TM dash mounted level control here. (The remote
level control will bypass the amplifier’s on board QBASS TM control.
1 1 2 3 4
DCX1000.1, 1500.1
Rear Panel
QBASS
REMOTE
QBASS
0 +16
DCX500.1
Rear Panel
QBASS
REMOTE
QBASS
0 +16
1 2 3 4
14