Pandigital PAN1802A - Manual (Page 5)

5
DPF Key Features
ƒ 1.8” Bright Color TFT LCD screen
ƒ Internal rechargeable battery
ƒ USB port for photo file transfer and for charging battery
ƒ 4 buttons (Power, Delete, Next and Previous)
ƒ Supported photo file type: JPEG
(stores up to 51 photos at 65K color resolution)
ƒ Li-ion ploy battery 3.7V last up to 6 hours when fully charged
ƒ USB1.1 full-speed connection to connect to your PC
ƒ Built-In Flash Memory
To learn more about your new DPF’s features and take full advantage of
them, please take a few minutes to read this User Guide.
Setting Up the DPF
The DPF is easy to set up. Just follow these steps:
1 Plug the USB cable into the DPF and into the computer USB slot.
2 Software Installation (Note: Some steps below may vary
depending on your operating system)
2.1.1 Insert the CD-Rom disk into your computers CD-Rom
drive.
2.1.2 Open “My Computer” and browse your CD-Drive. Double
click on Image Shuttle.exe, and accept all the default
settings by clicking OK.
2.1.3 Plug the USB cable end marked “B” into the digital
picture frame, then plug side “A” of the USB cable into
your computer’s USB port.
2.1.4 Windows will auto detect the digital picture frame device
and install the required device driver. (A reboot is not
required if the device is detected, if not please log out or
reboot your computer.) The device should now be
installed. If not, please consult your operating system’s
user manual on how to install device drivers.