Paradyne 6382 - Manual (Page 58)

3. Using the Web Interface
3-34 April 2005 6382-A2-GB20-00
3. Specify the Protocol. The protocol is dependent upon the entire network. Most
networks support RIP v1. If RIP v1 is selected, routing data will be sent in
RIP v1 format. If RIP v2 is selected, routing data will be sent in RIP v2 format
using subnet broadcasting. If Rip v1 Compatible is selected, routing data will
be sent in RIP v2 format using multicasting.
4. Specify the Direction. This determines the direction that RIP routes will be
updated. Selecting In means that the router will only incorporate received RIP
information. Selecting Out means that the router will only send out RIP
information. Selecting both means that the router will incorporate received RIP
information and send out updated RIP information.
5. The Apply button will temporarily save these settings. To make the change
permanent, click on Tools and select System Commands. On the System
Commands page, click on Save All.
Figure 3-29. Dynamic Routing