Paradyne 6371 - Manual (Page 127)

C. Traps and MIBs
6300-A2-GB20-00 March 2002 C-17
Configuration MIB
The supported groups used with the DSL Configuration MIB, pdn_Config.mib, are:
T Device Configuration Copy Group
T Trap Configuration Group
T Paradyne Device Configuration Time Group
T Traps
Table C-10. Device Configuration Copy Group Objects Table
Object Description Setting/Contents
devConfigAreaCopy
(devConfigArea1)
Use to configure the current configuration
to the factory defaults settings.
NOTE: ALL current configuration input is
purged when the DSL router is resets as a
result of this command. Data purged
includes:
– Interface IP addresses
– IP route table entries
– ARP cache entries
– NAT entries
– DHCP server entries
T noOp (1) – always reads as this value
and represents:
factory1-to-active(8)
devConfigTrapEnable
(devConfigTrap1)
This object determines which trap types are
sent, represented by a bit map as a sum.
Allows multiple trap types to be enabled or
disabled simultaneously. Bit positions:
T 1 – warmStart trap
T 2 – authenticationFailure trap
T 4 – enterpriseSpecific traps
T 8 – LinkUp trap
T 16 – LinkDown trap
devConfigTimeOfDay
(devConfigTime 1)
Displays the current time. —
cCN(7) Signifies a configuration change or a
software upgrade. T 7 – Warning trap
cCNTrapEnable
(router 28)
Use to enable or disable the configuration
change trap. T 1 – Disable trap
T 2 – Enable trap