Local console access, Changing access session levels – Paradyne 6371 User Manual
Page 20
2. Accessing the DSL Router
2-2
March
2002
6300-A2-GB20-00
Local Console Access
Your user account can be configured with one user login name and different
passwords for accessing a CLI session. The DSL router ships with the local
console enabled. After login, the local console can be disabled.
T
To disable with the local console, type:
console disable
save
exit
Press Enter after each command that you type.
Entering
console disable
results in NO local access to the DSL router. If
you attempt to log in, you will receive an error message.
After saving this change and ending the session, there is no local access
through the console port. Any access must be through a Telnet session or
the NMS.
T
To determine via a Telnet session whether a console is enabled, enter:
show console
One of the following messages is returned:
—
console enabled
– Command line management is available at the
console.
—
console disabled
– No command line management is available at the
console.
Changing Access Session Levels
T
To change the Administrator access level, enter:
admin enable
This command provides Administrator access privileges. The router responds
with a prompt to enter the password for Administrator access.
T
To end the Administrator access level, enter:
admin disable
This command ends the Administrator session. No password is needed.
Entering
exit
has the same result. Refer to
page 2-7 for further details on ending a session.
T
To determine the access level for a session, refer to