Paradyne 6371 - Manual (Page 90)

A. Command Line Interface
A-18 March 2002 6300-A2-GB20-00
PPPoE Client Commands
PPPoE Client commands will only be supported for the Hotwire 6351 ReachDSL
Router, and only when the ReachDSL Router is configured for IP routing (bridging
must be disabled) and is operating in VNET mode.
See PPPoE Client Support in
Chapter 3, Configuring the DSL Router for more information.
Table A-13. PPPoE Client Commands (1 of 2)
pppoe { enable | disable }
Minimum Access Level: Administrator
Command Mode: Config
Enables or disables PPPoE client support in the service domain.
enable – Enable PPPoE client support in the service domain. When the PPPoE client is
enabled, Proxy ARP for the DSL interface must be disabled and no upstream next hop
routers should be defined for the DSL interface.
disable – PPPoE client support is not available. This is the default setting.
ppp ip { eth1 | dsl1 } [ mask ]
Minimum Access Level: Administrator
Command Mode: Config
Specifies the interface to assign the PPP negotiated IP address for the ReachDSL
Router. The IP address is negotiated during the network-layer protocol phase of PPP.
NOTE: This IP address is retained through a power reset and does not cause the
ReachDSL Router to reset. However, a change to this option does not take effect until
the next PPP link establishment. At that time, the new configuration determined by this
IP address and its assigned interface will overwrite the current configuration.
eth1 – The negotiated IP address will be assigned to the Ethernet interface of the
ReachDSL Router. The DSL interface will then be automatically configured as
unnumbered, and any IP address(es) previously assigned to the Ethernet and DSL
interfaces are removed. A route for the subnet defined by the negotiated IP address
assigned to the Ethernet interface will automatically be added to the IP routing table.
NOTE: An attempt to assign the negotiated IP address to the Ethernet interface when
NAT is enabled will be rejected since the DSL interface must be numbered when NAT
is enabled.
dsl1 – The negotiated IP address will be assigned to the DSL interface of the ReachDSL
Router. Any IP address(es) previously assigned to the DSL interface are removed. The IP
address(es) assigned to the Ethernet interface remain intact unless there is a conflict with
the negotiated IP address. IP address assignment to the Ethernet interface is the
responsibility of the user when dsl1 is selected. This is the default setting.
mask – The subnet mask associated with the PPP negotiated IP address. If the mask is
not specified, it is derived based on the class of the negotiated IP address (A, B, or C).