Patton electronic 2720/I Series - Manual (Page 12)

11 12
3.1.2 Switch S1
The chart below shows the default configurations for Switch S1. A
description of all S1 options follows this table.
Switch S1-1: RDL Type
Switch S1-1 selects the type of Remote Digital Loopback that the
2720 will initiate when the RDL is initiated from this unit. The 2720 will
respond to both the V54 and the CSU loopback regardless of the set-
ting of S1-1
S1-1 RDL Type
On Initiate a V.54 RDL loop when selected
Off Initiate a CSU loopback when selected
Switch S1-2: Reserved
Switch S1-3: Tx Clock Invert
Switch S1-3 allows the user to invert the transmit clock originating
in the 2720. When S1-2 is set for transmit clock, it may be necessary
to invert the transmit clock to allow for delays due to long cables.
S1-3 Tx Clock Invert
On Transmit clock is inverted
Off Transmit clock is normal
Switches S1-4 and S1-5: Line Build Out
Use Switches S1-4 and S1-5 to set the Line Build Out (LBO). The
Line Build Out varies the pulse shape and attenuation of the signal
sent to the network. The amount of Line Build Out depends on
NetLink™ T1’s distance to the last repeater. The telephone company
providing the service will advise on the amount of LBO necessary. In
most cases the default setting will suffice.
SW1-4 SW1-5 Function
Off Off (0dB)
On Off -7.5dB
Off On -15.0dB
On On -22.5dB
Switch S1-6 Through S1-8: Reserved
3.2 SOFTWARE CONFIGURATION
The Model 2720 features a menu-driven command system that
allows you to monitor/configure its operating parameters. Follow the
instructions below to configure the Model 2720 using the software
selections:
1) Plug the 9-pin male end of the cable to your terminal or com-
puter’s DB-9 serial port and start up the terminal emulator
software if necessary. Plug the miniature stereo plug into the
rear of the unit. The small recessed jack on the left side of
the unit is the control port jack.
NOTE: If your terminal uses a DB-25 connector, please use a
DB-9 to DB-25 Adapter to connect to the cable.
2) Power up the terminal and set its RS-232 port as follows:
9600 Baud
8 data bits, 1 stop bit, no parity
Local echo off
ANSI or VT-100 emulation
S1 SUMMARY TABE
Position Function Factory Default Selected Option
S1-1 RDL Type On
S1-2 Reserved On
S1-3 Tx Clock Invert Off
S1-4 Line Build Out Off
S1-5 Off
S1-6 Reserved Off
S1-7 Reserved Off
S1-8 Reserved Off
V.54 RDL
Normal
0dB