Panasonic AW-PH650N - Manual (Page 29)

29
Connections
 Precautions when controlling the
AK-HC1500 from the AW-CB400
The AK-HC1500 supports the AK-HRP150 protocol and
AW-CB400 protocol, and it is the AK-HRP150 protocol
which was set before the AK-HC1500 was shipped from the
factory.
When controlling the AK-HC1500 using the AW-CB400,
follow the steps below to change the protocol setting of
AK-HC1500 from AK-HRP150 to AW-CB400.
 When changing the protocol before installation
Refer to the operating instructions of the AK-HC1500,
and change the protocol.
 When changing the protocol after installation
 Proceed with the installation following the steps given
in the section entitled “Installation”.
 Loosen the two top cover open/close bolts of the
camera housing, and open the top cover.
 Set the power switch of the AC adapter to ON.
 When the power of the AK-HC1500 has been
turned on, refer to the operating instructions of the
AK-HC1500, and change the protocol. (Change the
PROTOCOL setting on the SETTING menu to “4.”)
 Set the power switch of the AC adapter to OFF.
Connections with AC adapter
 Disconnect the AC power cable which was already
attached.
 The cable used is purchased locally. Purchase a water-
proof cable designed to be used outdoors.
 Use a cable which has a high enough capacity (AC 120 V
2 A or more).
 Pass the cable through the rubber bushing for the AC
power input cable, and tighten it securely so that rain
water or drops of water will not seep inside.
[Thickness of compatible cable: 1/4” to 5/16” (6.5 to 8.5 mm)
diameter]
 Attach the power line (N, L) to the terminal block.
 Attach the ground line (FG) to the grounding screw ( ).
AC IN
DC15 V
OUT
AC power
input cable
Rubber bushing
FG
N
L