Panasonic EY6105 - Manual (Page 4)

IV . FUNCTIONAL DESCRIPTION V . ASSEMBLY
CAUTION:
• Always remove battery pack when
attaching or removing a bit.
• Drill bit blade has sharp edge.
Pay attention to handle it.
This tool is equipped with a keyless
drill chuck.
CAUTION:
• EY6105 is designed to use only
battery pack type EY9005.
• Use with other battery pack type may
damage the tool and the battery, and
may result in the risk of fire and
personal injury.
CAUTION:
• To reduce the risk of injury, wear safety
goggles or glasses with side shieldes.
(A) Keyless drill chuck
(B) Clutch handle
(C) Speed selector switch
(D) Forward / Reverse lever
(E) Battery pack release button
(F) Battery pack (EY9005)
(G) Bit holder (inside of the body)
(H) Variable speed control trigger
( I ) Battery charger (EY0005)
Attaching or removing bit
VI . OPERATION
Trigger Switch Operation
Attaching or removing
battery pack
1. Attachment
Turn the part (a) counterclockwise
(looking from the front) to insert a bit.
Hold the part (b) and turn the part (a)
clockwise (looking from the front) to
tighten firmly until it stops.
Check the bit not coming out.
1. To connect the battery pack:
Insert the battery pack. It snaps into
place to indicate proper connection.
Make sure the battery is securely
connected to the tool.
2. To remove the battery pack:
Press the two battery pack release
buttons on the sides of the battery pack.
Slide the battery pack out of the tool
body.
1. The speed increases with the amount
of depression of the trigger. When
beginning work, depress the trigger
slightly to start the rotation slowly.
2. The brake operates when the trigger is
released and the motor stops
immediately.
2. Removal
Turn the part (a) counterclockwise
(looking from the front).
Remove the bit.
3. Storage
Keep the bit in bit holder when not in
use.
Remove the battery pack to store the bit
inside the handle
housing.
Bits up to 45 mm
(1-3/4 inch) long
can be stored here.
NOTE:
If the keyless drill chuck should
become loose on its mounting:
Hold the drill in place
and turn the part (b) in
the clockwise direction
(looking from the front).
Hold part (b) and turn part (a) in the
counterclockwise direction (looking
from the front) to open the chuck jaws.
Use a slotted screwdriver to firmly
tighten the fastening screw (left-
handed screw) of the keyless drill
chuck in the counterclockwise
direction (looking from the front).
NOTE:
• When the brake operates, a braking
sound may be heard. This is normal.
English-06-07
— 7 — — 6 —
(A)
(H)
(G)
(F)
(E)
(D)
(B) (C)
(I)
45 mm
(b) (a)
(a)
(b) (a)