Panasonic 16-185 - Manual (Page 7)

7
OPERATION
1. Extend the built-in rod antenna.
2. Press POWER to turn on the TV.
3. Press VHF/UHF to select VHF or
UHF. The TV starts scanning and
stops at the next active channel in
the selected band. A vertical blue
line moves across the screen
when scanning VHF channels; a
vertical green line moves when
scanning UHF channels.
Note: If the scanning line appears
vague or the tuned channel can-
not be locked when operating in
battery power, the batteries might
be weak. Replace them with new
alkaline batteries.
4. Press CHANNEL < or > to tune to
the desired channel. The scan-
ning line on the screen aligns with
the selected channel number
below the screen and then disap-
pears when the channel is
received.
To adjust the brightness, press
BRIGHT – or + . The brightness
also changes with the screen's
angle.
To adjust the volume, press VOL-
UME – or + .
5. Slowly adjust the antenna direc-
tion to get the best picture.
Notes:
• If desired, fold out the stand on
the back of the TV and lean the
TV on a flat surface at a conve-
nient angle. The stand can also be
used as a handle to carry the TV.
• If reception is poor, adjust the
length or angle of the rod antenna.
If inside a metal or concrete build-
ing, moving closer to a window
might improve reception.
• Be sure to attach the connecting
jacks' cover on the back securely
when operating the TV in a wet
area.
16-185.fm Page 7 Saturday, May 8, 1999 2:30 PM