Chapter 3 initial setup, Preparation, Procedures – Planet Technology ICA-101 User Manual
Page 10: Initial setup
7
Chapter 3
Initial Setup
Preparation
The initial setup of ICA-101 series must be done through bundled Setup Wizard utility.
Before starting installation, please ensure that:
·
Your PC can establish a physical connection to the Internet Camera. The PC and
the Internet Camera must be directly connected (using the LAN port on the Inter-
net Camera) or on the same LAN segment. That is, the PC must be configured to
an IP address and subnet mask in 192.168.0.x segment. For example: IP:
192.168.0.2, subnet mask: 255.255.255.0.
·
The Internet Camera must be installed and powered ON.
·
If the Internet Camera's default IP Address (192.168.0.20) is already used by
another device, the other device must be turned OFF until the Internet Camera is
allocated a new IP Address during configuration.
Procedures
1. Insert the CD-ROM into the CD-ROM drive to initiate the autorun program. Once
completed, a menu screen would appear as follow.
2. Click on Setup Wizard hyperlink to activate the initial setup.
If the above screen is not shown, you can start the installation as follows.
• Click on Start Menu/ Run.
• Enter “D:\Utility\wizard.exe” in the appeared box, where “D” is the letter of your
CD-ROM drive.
• Click on “OK” button.
3. Once the wizard is activated, it would search available camera automatically.
3