Rs-232c adjustment mode, 4 combination connection – Pioneer Plasma Display Panel PDP-504CMX User Manual
Page 6
4
5.5.4 Combination Connection
When performing control and adjustment, it is convenient to connect several sets to one PC.
By performing a combination connection and assigning IDs to the sets, it is possible to control and adjust several sets
at the same time or separately.
Connection method:
Connect the sets as shown in the figure below, and perform control and adjustment with the PC.
Only the combination IN terminal or RS-232C terminal can be used at the same time on one set. Connecting them at
the same time could cause erroneous operation or be the cause of trouble, so do not connect them at the same
time. Also, do not connect pair of combination IN terminals or combination OUT terminals. Doing so could cause
trouble.
It is possible to use a general-purpose mini DIN 6-pin (straight) cable for the combination cable.
Note
To output RS-232C signals from the combination OUT terminal, an ID must be assigned.
For details, refer to section, 5.5.3, ‘ID Assignment’.
RS-232C Adjustment Mode
IN
OUT
RS-232 C
IN
OUT
IN
OUT
RS-232 C
COM BIN ATION
RS-232 C
COM BIN ATION
COM BIN ATION
First set
Second set
Third set
Combination cable
Combination cable
PC
OUT
IN
IN
OUT
Note