Planar TOUCH SCREEN LCD MONITORS PT1700MX - Manual (Page 13)

11
Connecting the Display (Figure 11.1)
To setup this display, please refer to the following figure and procedures.
1. Be sure all equipment is turned off.
2. Connect the AC power cord to the power connector on the monitor and the
other end into an electrical outlet (11.1).
3. Connect the D-SUB cable from the display’s VGA input connector to the
D-SUB connector of your host computer and tighten the screws (11.1).
4. Connect the Audio-In cable from the audio input port of your display to the
Audio-out port of your computer (11.1).
5. Connect the RS-232 or USB cable from the RS-232 or USB port of your
display to the RS-232 port (11.1) or USB port (11.1) of your computer.
6. Configure the touch screen. Refer to the “Touch Screen Driver
Installation” section on Page 20.
7. Once the touch screen is configured, the monitor is ready for use.
To ensure the LCD display works well with your computer, please configure
the display mode of your graphics card to make it less than or equal to 1280
x 1024 resolution and make sure the timing of the display mode is
compatible with the LCD display.
We have listed the compatible “Video Modes” of your LCD
display in the appendix for your reference.